Würth Elektronik Extends Miniature SMT Ferrites with Top Filter Properties

  • Posted by doEEEt Media Group
  • On August 7, 2020
  • 0
    • 0 likes
The SMDs are AEC-Q200 qualified as part of Würth Elektronik’s automotive electronics portfolio. WE-CBA features high-quality Ni-Sn electrodes, a very high current carrying capacity up to 6 A, and operating temperatures from -55 to +125ºC. The ferrites, which are available in various specifications, are ideally suited as data line filters and for decoupling the supply voltage.

TDK EPCOS Robust Power AC Filter Film Capacitors Design Explained

  • Posted by doEEEt Media Group
  • On July 21, 2020
  • 0
    • 0 likes
AC filter capacitors are supplied with very high power ratings. According to the IEC-61071 standard for capacitors in power electronics, a safety device is mandatory for power capacitors, which activates the capacitors in the event of a fault.

EMC CL and LC Filters Comparison

  • Posted by doEEEt Media Group
  • On May 25, 2020
  • 0
    • 0 likes
First, the insertion loss a general filter is defined, and then the impact of the source and load impedance on the insertion loss is investigated. Simulations and measurements focus on the CL and LC filters. In Part II (to appear in the next issue) the performance of the Pi and T filters is evaluated and compared to that of the CL and LC filters.

The Top Five Reasons Products Fail EMI Testing

  • Posted by doEEEt Media Group
  • On May 25, 2020
  • 0
    • 0 likes
PC Board Design—Poor layout and layer stack-up Cable Shield Termination and Pigtails—Cable shields are not terminated to an enclosure or lack of common-mode filtering for unshielded products, plus shield pigtails used Gaps in the Return-Path—High-frequency clocks or signals crossing gaps in the return path Power Distribution Design—Poor power distribution network (PDN) design Shielding Design—Apertures or slots in the shielded enclosure that are too long

Ceramic Feedthrough Filters Explained

  • Posted by doEEEt Media Group
  • On May 8, 2020
  • 0
    • 0 likes
EMI is a serious concern for devices that are externally powered (ones that have a plug) or require signal wires that need to extend outside the device (signal wires that might attach to sensors or input/output devices). The wires that connect to power sources, or I/O points, can act as antennas that will allow EMI to be received (coupled onto them) and enter the device.

Vishay Expands its Low profile, High Current E-Shield Reduced EMI Inductor Series

  • Posted by doEEEt Media Group
  • On April 29, 2020
  • 0
    • 0 likes
The devices released today contain the electric and B field associated with EMI in a tin-plated copper integrated shield, providing up to -20 dB of electric field reduction at 1 cm (above the centre of the inductor) when the integrated shield is connected to ground. Featuring high-temperature operation to +155 °C and coplanarity of their four terminals within ≤ 100 µm, the inductors are optimized for energy storage in DC/DC converters up to 2 MHz and provide excellent attenuation of noise in high current filtering applications up to the SRF of the inductor.
doEEEt.com